Moorwood Vulcan MLE30F-F-C Uživatelský manuál stáhnout pdf (Strana 13)

Manual Part No: 930087-01 SNORKEL Gas Convection Oven - 13 –

Manual Rev No: 1

Installation (cont.)

Checking and Commissioning

ALTHOUGH EVERY APPLIANCE IS TESTED AND SET BEFORE IT LEAVES THE FACTORY, IT IS

IMPORTANT THAT THE INSTALLER RE-CHECKS CERTAIN FUNCTIONS BEFORE LEAVING THE SITE.

CHECK THE GAS PRESSURE AT THE APPLIANCE THUS: -

The pressure test point is located on the manifold pipe behind the removable lower fascia panel, which

is secured by two M5 screws.

Connect a manometer (U tube) to the test point. Turn on the gas supply and light and light the oven.

Check that the pressure reading agrees with the stated on the Data Plate.

Go through the lighting procedure, as listed in the

USER INTRUCTIONS, ensuring that all the neon lights

work and leave the oven set to 175°C for 20 minutes to ensure that it heats up and that the burner (and

red light) goes out when the temperature is reached.

SHOULD ADJUSTMENT BE NECESSARY, PROCEED AS FOLLOWS: -

FOR PROPANE GAS, the appliance governor (fitted to the solenoid valve) is disabled at the factory,

therefore any gas pressure problems should be

REFERRED TO YOUR GAS SUPPLIER.

On the gas governor: - (part of the solenoid valve).

Remove the cap in order to gain access to the pressure adjusting screw.

Turn the pressure adjusting screw clockwise to increase the pressure or anti-clockwise to decrease it.

When the pressure reading is correct, refit the cap to the governor.

Turn the gas supply to the unit

OFF at the stopcock and disconnect the manometer (U tube). Ensure that

the pressure test point screw is refitted.

Turn the gas supply to the appliance on at the stopcock and leak test the pressure test point.

Burner Aeration

The aeration of the burners is fixed and does not need adjusting.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 50 51

Žádné komentáře

Moorwood Vulcan MLE30F-F-C Uživatelský manuál Strana 13